Methods of Improving the Working Efficiency of Dry Magnetic Separator Equipment
1. When using dry magnetic separator equipment, we can increase the working efficiency of the equipment by adding a leveling device. The leveling device can make the dry separation layer thin and uniform. Generally speaking, the farther the magnetic separator is from the drum surface, the stronger the magnetic attenuation will be. The thicker the material flow will cause the magnetic particles and non-magnetic particles to be intermingled with each other, which will affect the sorting effect of the ore. The distribution is better.
2. Secondly, we can also adjust the distance between the magnetic roller and the dividing plate. According to the nature of the ore and adjusting the distance between the dividing plate and the drum, the gangue can be fully thrown out, while ensuring the full recovery of magnetic products and the recovery rate of the dry concentrate.
3. Another method is to adjust the height of the dry separator plate, and adjust the height of the dry separator plate according to the specific situation, so that the dry separator can not only ensure a certain proportion of tailings, but also obtain non-magnetic minerals. Better throw. The separator plate of the magnetic separator directly affects the separation effect of the magnetic separator. The separator plate is too low, so that the extremely lean magnetite ore can not be recovered well, and the utilization rate of ore resources is reduced. The separator plate If it is too high, the gangue minerals will not be thrown out completely, which will affect the sorting effect of the dry magnetic separator.
The above three points are the methods that can effectively improve the working efficiency of dry magnetic separator equipment compiled by the editor of Wandaye Magnetic Separation Equipment. I hope that the above introduction can help you.
PREV：Energy saving and environmental protection has become a new development direction of slurry magnetic separator
NEXT：Magnetic separator manufacturers share the steps of beneficiation and purification